UNKA ENGINEERING TECHNICAL PORTFOLIO
Process Equipment Fabrication & Testing
UNKA ENGINEERING coordinates the fabrication of columns, vessels, heat exchangers, tanks, structures and piping assemblies for process plants. Manufacturing follows approved drawings, material traceability, welding procedures, inspection plans and project-specific testing requirements.
PROCESS EQUIPMENT
Distillation ColumnsPurpose-built separation vessels with coordinated hydraulic, mechanical and fabrication engineering.OPEN DEDICATED PAGE →Column InternalsMass-transfer and distribution hardware selected for capacity, efficiency, turndown and fouling behavior.OPEN DEDICATED PAGE →Shell-and-Tube Heat ExchangersHeat-transfer equipment engineered for duty, pressure drop, vibration, fouling and maintainability.OPEN DEDICATED PAGE →Process CondensersCondensing service equipment configured for vapor composition, pressure level and non-condensables.OPEN DEDICATED PAGE →ReboilersVapor-generation equipment selected around circulation, fouling, temperature approach and controllability.OPEN DEDICATED PAGE →Pressure Vessels & DrumsCustom separators, accumulators and process vessels designed for operating and upset cases.OPEN DEDICATED PAGE →Process ReactorsReactor vessels integrated with catalyst, thermal, mixing and pressure-system requirements.OPEN DEDICATED PAGE →Fired Heaters & Process FurnacesProcess heating systems configured for duty, heat flux, fuel, emissions and safe operation.OPEN DEDICATED PAGE →Storage TanksAtmospheric and low-pressure tanks engineered for product, operating cycle and site loads.OPEN DEDICATED PAGE →LPG Bullets & SpheresPressurized LPG storage with coordinated process, mechanical and safety design.OPEN DEDICATED PAGE →Modular Process SkidsShop-integrated process modules developed for transport, installation and rapid commissioning.OPEN DEDICATED PAGE →Process Pump SystemsPump selection and system engineering matched to hydraulics, fluid properties and operating envelope.OPEN DEDICATED PAGE →
MANUFACTURED PROCESS EQUIPMENT
Process Separators & DrumsTwo-phase, three-phase, flash, reflux, knock-out and surge vessels engineered for actual phase behavior and operating envelope.OPEN DEDICATED PAGE →Air-Cooled Heat ExchangersFinned-tube air coolers for process condensation or cooling where ambient air is the heat sink.OPEN DEDICATED PAGE →Cooling TowersEvaporative cooling systems engineered from plant heat load, climate and water chemistry.OPEN DEDICATED PAGE →Industrial Filters & Filtration SkidsPressure, cartridge, bag, coalescing and media filtration packages selected from contaminants and product cleanliness targets.OPEN DEDICATED PAGE →Process Platforms & Structural ModulesAccess and support structures engineered with equipment, piping, maintenance and transport requirements.OPEN DEDICATED PAGE →Pipe Racks & Equipment StructuresIntegrated structures supporting process piping, cable trays, utilities and equipment while preserving access and expansion behavior.OPEN DEDICATED PAGE →Prefabricated Process Piping SpoolsShop-fabricated piping assemblies produced from approved isometrics for controlled field installation.OPEN DEDICATED PAGE →Pump & Rotating-Equipment PackagesIntegrated pump packages with driver, seal, baseplate, piping and instrumentation matched to system hydraulics.OPEN DEDICATED PAGE →Shop & Field-Fabricated TanksAtmospheric and low-pressure tanks manufactured for product, intermediate, utility and chemical storage.OPEN DEDICATED PAGE →